Sounds

Rosetta is setup to make these sounds when certain conditions.

The Sounds and What Makes Them Happen

Sound Sounds when Does not sound when Can be Played On
Signal Tower Monitor Speaker Both
**********************************
Fault siren
Fault siren

One steady, 3-second sound

  • An axis has a following error,
  • A limit switch has tripped, or
  • The Base Box or Expansion Box has lost contact.
  • E-Stop is pressed,
  • Machine is turned off, or
  • Program is stopped.
✅ ✅ ✅
**********************************
Done
Done

Three short beeps

  • The operation is stopped part way, by
    • Stop,
    • E-Stop,
    • turning the machine off, or
    • An error.
  • Return to Start does not beep.
✅ ✅ ✅
**********************************
Pause
Pause

Two short beeps

  • A Gcode program stops at an M0 or M1 and is waiting for you to continue it.
  • You press the Pause button yourself.
✅ ✅ ✅
**********************************
Startup Abort
Startup abort sound

Two short tones

  • The gcode directory① has one or more files using a reserved file name, and
Startup File Check is set to Abort startup, or
  • The gcode directory① does not have files using a reserved file name.
  • The gcode directory① has one or more files using a reserved file name, and
Startup File Check is set to Warn, but let me continue, or
  • The gcode directory① does not have files using a reserved file name.
❌

②

✅ ❌

Notes

  1. The default gcode directory which is checked is:
/home/reuben/linuxcnc/configs/Rosetta/gcode/
  1. This is due to these conditions for sounding an error are identified before LinuxCNC has started up and loaded the HAL; thusly, there is no ability to send a sound to the signal tower.
  2. The sound heard from the signal tower will typically be different from the sound heard on the monitor speaker. This is because there are options for changing the tone and/or harmonics on the monitor’s speaker, and these are not available on the signal tower (which is either on or off).

Configuring Sounds

The use of sounds with Rosetta is setup on the Inputs, Outputs, and Sounds tab in the Rosetta Settings program.

The startup abort sound is different - it is set by the Startup File Check choice on the Other tab instead, since it can happen before Rosetta Settings' other sound choices are even running.

########## Standard Footer for all pages ##########
spacer line

About the Rosetta System
Terms of Use

eMail comments to
ColvinTools @ Gmail [period] com -> mailto:ColvinTools [snail] Gmail [period] com